Item # MG-3F, MW & MG Series Female Rod Ends, General Purpose

Body - Low carbon steel, protective coated for corrosion resistance. Size 16 standard series body is alloy steel not heat treated.
Ball - Alloy steel, heat treated, hard chrome plated.
Race - Low carbon steel, protective coated for corrosion resistance.
Left-hand threaded units have an identification groove near end of shank.
Grease Fitting available for sizes -3 and up. Units are supplied without grease fittings. When a grease fitting is required, specify by adding suffix "Z" or "F". Ex.: MW-6Z = Zerk Type Fitting MW-6F = Flush Type Fitting.
Load ratings apply only to rod ends without grease fittings. For load ratings with fittings, please consult our engineering department.
Studded configuration available upon request. Specify by adding suffix "S". Ex.: MW-8S.
PTFE Liners available upon request. Specify by adding suffix "T". Ex.: MW-8T.

Unit of Measure

Specifications | MW & MG Note

Thread Type	N/A Left Hand
Thread Configuration	N/A Female
B - Ball Bore	N/A .1900 in
W - Ball Width	N/A .312 in
H - Head Width	N/A .250 in
A - Base to Center	N/A 1.062 in
D - Head Diameter	N/A .625 in
K - Shank Diameter	N/A .406 in
J - Wrench Flat Width	N/A .312 in
Ball Diameter	N/A .437 in
C - Thread Depth [inch]	N/A .562 in
Thread Size	N/A 10-32
Thread Class	N/A UNF-2B-LH
a - Misalignment Angle Clevis Mounted	N/A 13 º
Ultimate Radial Static Load Capacity	N/A Consult Engineering Department
Approximate Brg. Weight	N/A .04 lb
Options	N/A Stud
Type of Lubrication	N/A Flush Fitting

N/A For dimensional tolerances of listed features, see the PDF version of the catalog under the "View Product Catalogs" tab from the home page.

Thread Type