Item # MG-2, MW & MG Series Female Rod Ends, General Purpose

Body - Low carbon steel, protective coated for corrosion resistance. Size 16 standard series body is alloy steel not heat treated.
Ball - Alloy steel, heat treated, hard chrome plated.
Race - Low carbon steel, protective coated for corrosion resistance.
Left-hand threaded units have an identification groove near end of shank.
Grease Fitting available for sizes -3 and up. Units are supplied without grease fittings. When a grease fitting is required, specify by adding suffix "Z" or "F". Ex.: MW-6Z = Zerk Type Fitting MW-6F = Flush Type Fitting.
Load ratings apply only to rod ends without grease fittings. For load ratings with fittings, please consult our engineering department.
Studded configuration available upon request. Specify by adding suffix "S". Ex.: MW-8S.
PTFE Liners available upon request. Specify by adding suffix "T". Ex.: MW-8T.

Unit of Measure

Specifications | MW & MG Note

Thread Type	N/A Left Hand
Thread Configuration	N/A Female
B - Ball Bore	N/A .1250 in
W - Ball Width	N/A .250 in
H - Head Width	N/A .187 in
A - Base to Center	N/A .812 in
D - Head Diameter	N/A .500 in
K - Shank Diameter	N/A .312 in
J - Wrench Flat Width	N/A .250 in
Ball Diameter	N/A .312 in
C - Thread Depth [inch]	N/A .437 in
Thread Size	N/A 6-32
Thread Class	N/A UNC-2B-LH
a - Misalignment Angle Clevis Mounted	N/A 16 º
Ultimate Radial Static Load Capacity	N/A 1,202 lbs
Approximate Brg. Weight	N/A .02 lb
Type of Lubrication	N/A None

N/A For dimensional tolerances of listed features, see the PDF version of the catalog under the "View Product Catalogs" tab from the home page.

Thread Type